elliott
RRCRat Rig Community [Unofficial]
•Created by elliott on 6/5/2024 in #ratos-support
Euclid Probe Errors
I recently replaced the microswitch on my euclid with the same one that came from Euclid (D2F-5 SPDT)
I'm getting an error now that the probe is still stowed when it has been picked up and Klipper shuts down.
I checked continuity on the wires, everything is good.
The light on the probe works and shuts off when triggered.
When checking the endstop state it always says triggered, no matter if the probe is stowed, retrieved, or triggered.
6 replies
RRCRat Rig Community [Unofficial]
•Created by elliott on 5/28/2024 in #ratos-support
RatOS - All Repos show as Corrupt
29 replies
RRCRat Rig Community [Unofficial]
•Created by elliott on 5/4/2024 in #fix-my-printer
Error After Replacing Euclid Switch
2 replies
RRCRat Rig Community [Unofficial]
•Created by elliott on 2/3/2024 in #fix-my-print
Pitting after switching to 0.6mm nozzle
53 replies
RRCRat Rig Community [Unofficial]
•Created by elliott on 3/7/2023 in #fix-my-mesh
What adjustments do I need to make?
6 replies
RRCRat Rig Community [Unofficial]
•Created by elliott on 3/6/2023 in #ratos-support
Euclid Probe Deployment Error
44 replies
RRCRat Rig Community [Unofficial]
•Created by elliott on 3/2/2023 in #ratos-support
Include file '/home/pi/klipper_config/pam/ratos.cfg' does not exist
20 replies