Euclid Probe Errors

I recently replaced the microswitch on my euclid with the same one that came from Euclid (D2F-5 SPDT)

I'm getting an error now that the probe is still stowed when it has been picked up and Klipper shuts down.

I checked continuity on the wires, everything is good.
The light on the probe works and shuts off when triggered.
When checking the endstop state it always says triggered, no matter if the probe is stowed, retrieved, or triggered.

klippy.log354.14KB

moonraker.log14.82KB

printer.cfg21.15KB

blacksmithforlife•6/5/24, 12:13 PM

When checking the endstop state it always says triggered, no matter if the probe is stowed, retrieved, or triggered.

well there's your problem. Either the switch is bad or there is a wiring problem somewhere

elliottOP•6/10/24, 8:36 PM

Here’s the wiring as I have it currently.

There is positive conductivity between each end of the wires (white to white, black to black, etc) so I know there’s no breaks.

The probe sends GND on the black wire out which is then returned via sig to PA1.

The red is just there for the light from what I can tell.

Now, when the probe is deployed, it connects the red and white (GND & PA1). Testing this at the end of the wire where it connects to the actual board I get conductivity.

When the switch on the probe is pressed, the connection is broken. Testing at the connection to the board confirms this is the same at the wiring end.

Could I have a bad board somehow?

elliottOP•6/14/24, 6:19 PM

Should I try a fresh install?

Or do I have the polarity reversed and need to have a positive signal going back to PA1?

elliottOP•6/20/24, 2:08 PM

elliottOP•6/20/24, 2:09 PM

Hot dang I figured it out. That little guy was barely not connected. I resoldered it and now it’s working.