uzi 🇦🇹 Posts - Answer Overflow

uzi 🇦🇹

•Created by uzi 🇦🇹 on 12/6/2024 in #fix-my-printer

Noisy and jamming y rails after installing titanium tube

Hello. Do you have any tips on how to adjust the Toro axle correctly so that it runs smoothly and nicely and quietly without any ball noise? I managed to adjust the old original rail, which is why the two Y rails have to be parallel and I don't think I need to adjust them. But it seems to be jamming like this. If one side is loose then it runs better and more quietly but still not optimally. Where is the best place to loosen and tighten screws? Is the Toro titanium tube possibly jammed or twisted and do I also need to remove the M5 from the stacks?? They clamped the rails against the plate. Please help

37 replies

RRCRat Rig Community [Unofficial]

•Created by uzi 🇦🇹 on 9/5/2024 in #fix-my-print

Problems with smoothing the surface of ASA and ASA GF

2 replies

RRCRat Rig Community [Unofficial]

•Created by uzi 🇦🇹 on 9/2/2024 in #fix-my-print

Minion in Heated Chamber, Asa Problems with Edges

4 replies

RRCRat Rig Community [Unofficial]

•Created by uzi 🇦🇹 on 5/30/2024 in #fix-my-printer

my RPI Cam doesnt work

6 replies

RRCRat Rig Community [Unofficial]

•Created by uzi 🇦🇹 on 9/11/2023 in #german-support

rapido 2.0 Volcano

Hallo. Wie installiert man das CHT Volcano richtig mit der Mutter am Rapido 2.0 ohne das man das Hotend beschädigt? Hab ein Youtube Video gesehen und die haben das kalt gemacht. Aber wär es nicht eher richtig so mit 100grad mit 1-2nm handfest das Hotend reinzudrehen und dann zu kontern? Bitte um Hilfe

5 replies

RRCRat Rig Community [Unofficial]

•Created by uzi 🇦🇹 on 7/28/2023 in #german-support

v-minion