Erik_
RRCRat Rig Community [Unofficial]
•Created by Erik_ on 12/4/2024 in #fix-my-printer
Problem solve pulley system
Is there a way to problem solve the pulley system?
What components are driving the pulley system?
Can it be factory reset somehow?
5 replies
RRCRat Rig Community [Unofficial]
•Created by Erik_ on 12/3/2024 in #fix-my-printer
"Nothing to do: Z Offset is 0"
14 replies
RRCRat Rig Community [Unofficial]
•Created by Erik_ on 12/2/2024 in #fix-my-print
x & y offset in middle of print?
Hey. After the machine setup i wanted to get going with printing.
First i made a few flat tests to get the z-offset right.
After that i wanted to get going with printing my own designs.
However, it seems that i get some kind of offset problems after the first layer is set.
I have provided a video for you to see.
Why is it good the first layer and not the others?
63 replies
RRCRat Rig Community [Unofficial]
•Created by Erik_ on 12/1/2024 in #fix-my-printer
Calibrating machine guidance
121 replies
RRCRat Rig Community [Unofficial]
•Created by Erik_ on 11/29/2024 in #fix-my-printer
The value 'T0' is not valid for MACRO
64 replies
RRCRat Rig Community [Unofficial]
•Created by Erik_ on 11/20/2024 in #fix-my-printer
Klipper reports: ERROROption 'mesh_min' in section 'bed_mesh' must be specified.
48 replies