Problem solve pulley system
Is there a way to problem solve the pulley system?
What components are driving the pulley system?
Can it be factory reset somehow?
3 Replies
what is the issue you are having, because your question doesn't make a lot of sense?
Hi. My prints are unsuccessfully done. The toolhead is "shifting layers". Some kind of offset happens while printing. I figured that the belt has been tensioned too hard. After i eased the belts the print got better but is still bad. Sometimes the machine prints striaght in z sometimes it does not when it is suppose to. So i figured that the too hard tensioned belt has had an effect on the system and mabey damageing something. I do not know all the parts. That's why i figured i could ask here and have some input. Perhaps it also could be a software issue, but i thought that the too hard tensioned belts have broken something.
This is usually caused by:
* belt binding somewhere
* the gear on top of the stepper slipping because the setscrew hasn't been tightened down enough or not on the flat of the stepper shaft
* too high accelerations set in the slicer and the stepper misses steps
* over extrusion causing the printer nozzle to collide with the print and shift
As for too tight belts - you can run the belt analysis macro
MEASURE_COREXY_BELT_TENSION to see where it is out and ask for help in #fix-my-resonance