dyocis
RRCRat Rig Community [Unofficial]
•Created by dyocis on 11/20/2024 in #ratos-support
Generate Shaper graph kills printer
87 replies
RRCRat Rig Community [Unofficial]
•Created by dyocis on 11/14/2024 in #ratos-support
Wrong pin assignment for T1 part cooling fan
9 replies
RRCRat Rig Community [Unofficial]
•Created by dyocis on 11/7/2024 in #ratos-support
How to use an alias assigned pin for something else
7 replies
RRCRat Rig Community [Unofficial]
•Created by dyocis on 11/6/2024 in #ratos-support
Error after updating board
4 replies
RRCRat Rig Community [Unofficial]
•Created by dyocis on 10/26/2024 in #ratos-support
Error after most recent update
10 replies
RRCRat Rig Community [Unofficial]
•Created by dyocis on 10/15/2024 in #ratos-support
MCU or T0 or T1 running at the wrong Mhz
49 replies
RRCRat Rig Community [Unofficial]
•Created by dyocis on 10/11/2024 in #ratos-support
Not able to print with IDEX
I'm getting this error when trying to print: Error evaluating 'gcode_macro START_PRINT:gcode': gcode.CommandError: Something went wrong! Missing important post processor start print parameter!
I've added RatoS debug, my printer.cfg and ratos.cfg and the gcode I'm trying to print
185 replies
RRCRat Rig Community [Unofficial]
•Created by dyocis on 10/10/2024 in #ratos-support
IDEX config has T0 for both heads?
12 replies
RRCRat Rig Community [Unofficial]
•Created by dyocis on 10/6/2024 in #fix-my-printer
Lost communication with MCU 'toolboard_t0'
I'm running VC4 500 with a Orbitool board. Everything else is pretty much stock other than a 24v fan to the toolboard instead of the 4 wire fan back to the MB. I've tried multiple toolboards, USB pcbs, and cables. (I ordered 3, so I had 1 for IDEX and a spare)
It seems to work fine for 4 or 5 prints, then I get 3ish hours into a print and it shuts down due to "Lost communication with MCU 'toolboard_t0'" Then it does it every time I try to print something until I switch out the board or cable. Then it will work fine for 4 or 5 prints. I'm really stumped on this. All the connectors are stock, I didn't crimp anything. I've switched out previously removed boards and cables, and it will still print 4 or 5 prints without issue.
klippy log is attached.
klippy log is attached.
27 replies
RRCRat Rig Community [Unofficial]
•Created by dyocis on 9/27/2024 in #fix-my-mesh
Having issues with my 500
50 replies