SYG|Krizalid87
RRCRat Rig Community [Unofficial]
•Created by SYG|Krizalid87 on 11/8/2024 in #fix-my-mesh
VC 3.1 400 Fix back corner
My bed mesh is a little strange.
Everything seems to be ok but not the left back corner.
For your info I have the FMMM mod...
I follow the Gantry YT video but seems to be useless in this case.
I try to push higher my front left corner without results.
Thanks in advance
8 replies
RRCRat Rig Community [Unofficial]
•Created by SYG|Krizalid87 on 10/9/2023 in #fix-my-printer
remove magnetic adhesive sheet.
I have a strange mesh so i think and see a lot of air Bubbles trapped between magnetic adhesive sheet and metal bed.
Is there a simple way to remove the adhesive and replace with another One?
Do i warm the bed and peel off the adhesive sheet?
Best regards
Lorenzo
22 replies
RRCRat Rig Community [Unofficial]
•Created by SYG|Krizalid87 on 9/10/2023 in #fix-my-print
Strange Artifacts on First layer
15 replies
RRCRat Rig Community [Unofficial]
•Created by SYG|Krizalid87 on 8/31/2023 in #fix-my-print
Quality Improvements
3 replies
RRCRat Rig Community [Unofficial]
•Created by SYG|Krizalid87 on 8/29/2023 in #ratos-support
Connect HDMI monitor to Raspberry pi4 (RatOs)
Hello everybody,
I want to connect and external HDMI monitor without touch to my raspy4 (vcore 3.1).
I bought the adapter and try to connect tò the monitor but i have the NoSignal error.
Can you help me?
Best regards
8 replies
RRCRat Rig Community [Unofficial]
•Created by SYG|Krizalid87 on 8/7/2023 in #ratos-support
EBB42 1.2 + E3D Revo Voron RatOS Mcu Toolboard adc out of range
Hi Guys,
I have just finished to mount and connect my new Ratrig vcore 3.1 and installed Klipper following the guide on Ratrig website.
Once the configuration is finished I removed from ihe printer.cfg the # in the Hotend section next to the Revo and i removed the # also in the Toolboard section (i have the BTT EBB42 1.2 correctly flashed via RatOS configurator).
I always see the errore "Mcu Toolboard adc out of range" when i start Klipper.
This is the datasheet of the REVO Voron:
Max Printing Temperature: 300°C
Mass: ~25g
Temperature sensor type: thermistor, Semitec 104NT-4-R025H42G
Voltage options: 12V or 24V
Wattage: 40W
Filament diameter: 1.75mm
PS:
If I connect the Phaetus Rapido 2 to my toolboard and choose the Rapido into the Printer.cfg, i can read the temperature in the dashboard and the printer works fine.
Thank you in advance 🙂
14 replies