VC 3.1 400 Fix back corner
My bed mesh is a little strange.
Everything seems to be ok but not the left back corner.
For your info I have the FMMM mod...
I follow the Gantry YT video but seems to be useless in this case.
I try to push higher my front left corner without results.
Thanks in advance
5 Replies
I also think the back corner is difficult to fix with the frame, as the electronics panel doesn't allow easy moving of those corners.
Personally, I just put strips of thin tape between the magnetic sticker and the steel flex plate. It lets you correct small areas quite easily.
here, for example, I added a small section of tape to fix the drop in the back left. I will keep adding tape strips untill I'm below 0.1 mm - something like that
and then just by adding tape strips, I go from 0.19 to 0.07mm.
maybe i have also motors issue.
Not aligned properly
time to rebuild the printer