Jessica
RRCRat Rig Community [Unofficial]
•Created by Jessica on 12/3/2024 in #fix-my-printer
Massive Layer shift after 2 hours
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jessica on 7/7/2024 in #fix-my-print
flow issues at higher speeds
8 replies
RRCRat Rig Community [Unofficial]
•Created by Jessica on 6/25/2024 in #fix-my-resonance
VC4 500 hybrid y resonance speed low
9 replies
RRCRat Rig Community [Unofficial]
•Created by Jessica on 6/19/2024 in #fix-my-printer
hot end thermister reports 126.8°C when off
When setting a temperature or doing a calibration, the temp goes in the opposite direction and then klipper crashes.
10 replies
RRCRat Rig Community [Unofficial]
•Created by Jessica on 6/19/2024 in #fix-my-printer
Fresh V-Core 4 RatOS 2.1 RC1 klipper fails to connect
I've been attempting to start the commissioning process. I've flashed and reflashed the OS freshly multiple times. I continue to get that klipper cannot start.
moonraker logs are fine, but klipper fails. The first time the toolhead board reported no file or directory. This time the beacon is erroring in the log with no file or directory.
I'm not sure how to proceed forward.
4 replies