flow issues at higher speeds
So I'm printing a flat print with rectilinear infill. It's only about 25 layers high. Once we get past the first 3 layers, I'm seeing weird flow issues where there's gaps and blobs. Then the print head seems to move the blobs around and make a bad surface to layer anything on top. I'm not sure how to fix this issue.
This is on a V-Core 4 500mm.
Solution:Jump to solution
I've increased the temp about 5 degrees and dropped the max flow rate on the filament profile.
4 Replies
So the first three layers go down well?
Yes they did. I suspect the flow rate is too high for the filament / speed of the printer.
Solution
I've increased the temp about 5 degrees and dropped the max flow rate on the filament profile.
I'm trying again. We'll see what happens this time.
Yeah, that seems to have been it. The updated print is not showing this issue at all.