Fresh V-Core 4 RatOS 2.1 RC1 klipper fails to connect
I've been attempting to start the commissioning process. I've flashed and reflashed the OS freshly multiple times. I continue to get that klipper cannot start.
moonraker logs are fine, but klipper fails. The first time the toolhead board reported no file or directory. This time the beacon is erroring in the log with no file or directory.
I'm not sure how to proceed forward.
Solution:Jump to solution
OK the reason is because I had plugged the beacon sensor connector to the toolhead after screwing down the sensor, which didn't have enough room to fully seat while the sensor is mounted. I removed the sensor, firmly connected the cable, re-installed the sensor, and after that, everything start up.
2 Replies
I'm re-downloading RatOS 2.1 and re-flashing for the 3rd time just to be safe
Solution
OK the reason is because I had plugged the beacon sensor connector to the toolhead after screwing down the sensor, which didn't have enough room to fully seat while the sensor is mounted. I removed the sensor, firmly connected the cable, re-installed the sensor, and after that, everything start up.