dmeadows013
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 8/30/2024 in #fix-my-print
Uneven Extrusion on Infill
8 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 8/1/2024 in #fix-my-resonance
Belt Tension Alignment
1 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 11/12/2023 in #fix-my-print
Possible underextrusion?
10 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 10/10/2023 in #fix-my-printer
Z Movement Clicking? Bad noise
Started getting this clicking during Z Tilt/Homing earlier, nothing changed in the printer so I’m not sure what’s causing it. I made sure the lead screws are greased well, and the noise doesn’t happen during manual axis movements so it’s hard to troubleshoot. I attached a video of what it sounds like
4 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 10/6/2023 in #fix-my-print
Inconsistent Extrusion after travel
3 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 9/30/2023 in #fix-my-print
Spaghetti? not sure why
1 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 9/8/2023 in #fix-my-printer
PT1000 thermistor EBB42
Not able to boot into RatOS using an Octopus 1.1/EBB42 1.2, have a PT1000 connected to the toolboard and getting ADC out of range errors on the heating.
Added the following into my printer overrides, and put the jumper on the PT1000 pins on the EBB42 for TH0. I've tried this code with and without the sensor_pin line commented and it doesn't seem to make a difference, wondering if I might have a broken thermistor or if there could be a different problem.
#PT1000
[extruder]
sensor_type: PT1000
#sensor_pin: toolboard:PA3
pullup_resistor: 2200
10 replies