Z Movement Clicking? Bad noise
Started getting this clicking during Z Tilt/Homing earlier, nothing changed in the printer so I’m not sure what’s causing it. I made sure the lead screws are greased well, and the noise doesn’t happen during manual axis movements so it’s hard to troubleshoot. I attached a video of what it sounds like
3 Replies
Attached my config also if it helps, running through a couple prints and haven't heard the sound outside of during homing
Did you fix this? Having the same issue.
Don’t remember exactly how I solved the issue, I think it resolved on its own after a bit. My advice would be make sure the lead screw/rails are clean, rails are greased (not sure if the a screws need to be greased, but I don’t regularly lube them other than when I had this issue)