dmeadows013
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 10/10/2023 in #fix-my-printer
Z Movement Clicking? Bad noise
Don’t remember exactly how I solved the issue, I think it resolved on its own after a bit. My advice would be make sure the lead screw/rails are clean, rails are greased (not sure if the a screws need to be greased, but I don’t regularly lube them other than when I had this issue)
4 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 9/8/2023 in #fix-my-printer
PT1000 thermistor EBB42
This was solved; thermistor was broken
10 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 11/12/2023 in #fix-my-print
Possible underextrusion?
0.4 nozzle, set correctly in slicer
10 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 11/12/2023 in #fix-my-print
Possible underextrusion?
And yes, using Orbiter-1004 for orbiter V2
10 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 11/12/2023 in #fix-my-print
Possible underextrusion?
40% on 4028 fan, have tried 3 rolls (Polymaker, Hatchbox, and Overture) all PLA, usually print at 195 but having this issue anywhere from 195-215. Also played with retraction settings but nothing came of it
10 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 10/10/2023 in #fix-my-printer
Z Movement Clicking? Bad noise
Attached my config also if it helps, running through a couple prints and haven't heard the sound outside of during homing
4 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 10/6/2023 in #fix-my-print
Inconsistent Extrusion after travel
3 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 9/8/2023 in #fix-my-printer
PT1000 thermistor EBB42
Yeah thinking it might be broken, plugged it into the Octopus and same issue, so I ordered a new one will test when it gets here
10 replies
RRCRat Rig Community [Unofficial]
•Created by dmeadows013 on 9/8/2023 in #fix-my-printer
PT1000 thermistor EBB42
Same issue
10 replies