archen
RRCRat Rig Community [Unofficial]
•Created by archen on 12/8/2024 in #fix-my-printer
Octopus Pro 1.1 h723 fried
7 replies
RRCRat Rig Community [Unofficial]
•Created by archen on 11/25/2024 in #fix-my-printer
IDEX inconcistent nozzle alignment
Starting a thread about this issue. Posting graphs below.
Issues:
VAOC issues, nozzles doesn't go back to the saved position and during print they don't align well, offset in x, y is perfect.
Having hard time with the belts. Mainly t0 looks good but having problem getting t1 at same frequency and also the belt tension seems to vary along y.
Feels like t1 need higher tension than t0
VC4-400
102 replies
RRCRat Rig Community [Unofficial]
•Created by archen on 6/5/2024 in #ratos-support
Toolhead stopped below model range
18 replies
RRCRat Rig Community [Unofficial]
•Created by archen on 6/3/2024 in #fix-my-print
Move exceeds maximum extrusion on filament change
Vcore3.1 - Ratos 2.1 - Orca slicer
I'm trying to make a multi-color 1-extruder print. I have M600 in filament change g-code, using Orca..
On the first filament change after I changed filament manually and it tries to start printing again it errors out on this error:
14:24 Move exceeds maximum extrusion (3.116mm^2 vs 0.640mm^2)
It looks like it tries to prime blob into the purge tower but not sure...
I tried to print it without purge tower and then it didn't error out...7 replies
RRCRat Rig Community [Unofficial]
•Created by archen on 4/1/2024 in #fix-my-print
inconsistent overlap/bridge
11 replies
RRCRat Rig Community [Unofficial]
•Created by archen on 3/2/2024 in #fix-my-mesh
new idex build mesh 400 enclosed
3 replies
RRCRat Rig Community [Unofficial]
•Created by archen on 9/21/2023 in #ratos-support
Manta M8P v2.0 support
Is the new Manta M8P v2.0 supported? I see v1.1 is listed but not v2.0
14 replies