Animatrix
RRCRat Rig Community [Unofficial]
•Created by Animatrix on 4/9/2024 in #fix-my-mesh
Extremely terrible mesh, bad tilt
22 replies
RRCRat Rig Community [Unofficial]
•Created by Animatrix on 4/1/2024 in #fix-my-mesh
tilt even after Z_TILT_ADJUST and a very fine bed mesh
12 replies
RRCRat Rig Community [Unofficial]
•Created by Animatrix on 1/12/2024 in #fix-my-print
PETG infill top issues
7 replies
RRCRat Rig Community [Unofficial]
•Created by Animatrix on 10/10/2023 in #fix-my-resonance
Absolutely horrible frequency response
38 replies
RRCRat Rig Community [Unofficial]
•Created by Animatrix on 10/9/2023 in #fix-my-printer
y axis skipping at accel > 5k (V-core 3.1 500)
Not sure what's causing this exactly, i don't even know where to look tbh.
I've checked for squareness and it looks fine,
The belt seems to move a little vertically over the course of its motion.
The attached video shows an inverted V motion after homing, which doesn't complete.
This movement works at accels close to 5k and under. Sometimes for >5k. Repeatability is 50-50. Sometimes it works fine.
When i try printing something at those accels i have layer shifts towards the front-right. Each layer prints fine but the next layer considerabl offsets over the previous.
109 replies