RRC
Rat Rig Community [Unofficial]•9mo ago
Animatrix

Extremely terrible mesh, bad tilt

Not sure where to even start, i tried lifting/lowering the front right extrusion but the curve never goes away. Is it bowing in my Y rail ?
No description
No description
4 Replies
Animatrix
AnimatrixOP•9mo ago
firstly, the tilt is not even right i've tried altering the points its almost like the probe isn't doing anything i removed and checked all the screws, couplers no dice, all good. while the mesh looks like that ^, it kinda feels like my whole mesh is mirrored. Im not sure how that can happen. The left rear is too far away when i actually print something and nothing sticks right while in the mesh its the right rear thats far away, perhaps it is far too. Left rear corner - very far from plate, doesn't stick - perhaps (-)0.2mm Right rear corner - barely close, i would do -0.05 if i could Front left corner - goodW Front right corner - too close, i would add +0.1 if i could 
[bed_mesh]
horizontal_move_z: 5
mesh_min: 20,20
mesh_max:465,460
probe_count: 8,8
fade_start: 3.0
fade_end: 0.0
mesh_pps: 2,2
algorithm: bicubic
bicubic_tension: .2

[z_tilt]
z_positions:
    0,0
    250,500
    500,0

points:
    40,35
    280,470
    465,20
        
horizontal_move_z: 20
retries: 10
retry_tolerance: 0.02
[bed_mesh]
horizontal_move_z: 5
mesh_min: 20,20
mesh_max:465,460
probe_count: 8,8
fade_start: 3.0
fade_end: 0.0
mesh_pps: 2,2
algorithm: bicubic
bicubic_tension: .2

[z_tilt]
z_positions:
    0,0
    250,500
    500,0

points:
    40,35
    280,470
    465,20
        
horizontal_move_z: 20
retries: 10
retry_tolerance: 0.02
// probe accuracy results: maximum 2.652937, minimum 2.650437, range 0.002500, average 2.652525, median 2.652625, standard deviation 0.000557 25 samples // probe accuracy results: maximum 2.633562, minimum 2.632000, range 0.001562, average 2.632969, median 2.632937, standard deviation 0.000406 10 samples // probe accuracy results: maximum 2.632000, minimum 2.631062, range 0.000937, average 2.631687, median 2.631687, standard deviation 0.000280 10 samples klicky
Animatrix
AnimatrixOP•9mo ago
2nd mesh - didn't change much really
No description
VisualTech48
VisualTech48•9mo ago
First of all you are as you mentioned reading it backwards. BLUE means its FAR away Not that it goes down. That means if we go by your last mesh YOu need to either LIFT front right, or LOWER front LEFT
VisualTech48
VisualTech48•9mo ago
No description

Did you find this page helpful?