tilt even after Z_TILT_ADJUST and a very fine bed mesh
I can't wrap my head around this, it all worked fine before. Not sure what happened to it overnight.
2 Replies
It's as if there's a tilt despite everything i've done
all the processes went well
my range/variance are the same as before the issue
is it my Z motors ?
pretty much always the front is lower than the rear
using the included performance setting for Z motors as well
post a Z_TILT_ADJUST, any sort of Z movement seems to cause a tilt to come back
i'm going to try and remove the screws and clean them up
clean the oldham couplers and check if they're smooth
same with the rails