Woodside
RRCRat Rig Community [Unofficial]
•Created by Woodside on 9/10/2024 in #fix-my-print
Variations in Layer Lines Around Geometry Changes
6 replies
RRCRat Rig Community [Unofficial]
•Created by Woodside on 8/21/2024 in #fix-my-print
Zig-zag rippling on print
11 replies
RRCRat Rig Community [Unofficial]
•Created by Woodside on 11/26/2023 in #fix-my-print
Voids in layer after detail change
5 replies
RRCRat Rig Community [Unofficial]
•Created by Woodside on 11/22/2023 in #fix-my-printer
[Solved] Cooling Fan Speed Inverted
Cooling fan will be at 100% when set to 0% and vice versa. I double checked pin configuration and it is correct as per this:
https://d3t0tbmlie281e.cloudfront.net/igi/ratrig/Ddp1ogoUhwTkDXvc.huge
I assume this is an easy config change, but I am unsure where.
2 replies
RRCRat Rig Community [Unofficial]
•Created by Woodside on 5/7/2023 in #fix-my-printer
X gantry has a "sine"-like resistance variance when moving along Y
I don't know how else to describe it, but when I move the X gantry along the Y axis, the resistance follows a sort of sine wave.
This only started to occur after I followed the X alignment guide: https://ratrig.dozuki.com/Guide/10.+X-Axis+Gantry+Alignment/210
Prior, it was a linear (and negligible) change in resistance along the Y axis.
Is it something I should be concerned about?
15 replies
RRCRat Rig Community [Unofficial]
•Created by Woodside on 4/1/2023 in #fix-my-print
ASA first print
18 replies
RRCRat Rig Community [Unofficial]
•Created by Woodside on 3/31/2023 in #fix-my-print
"Heat soaking"?
Is this just something that's done the first few times I print to get everything settled in?
It seems like a hassle and a waste of energy to leave a printer heating for an hour before each print sesh, especially if one were to only print a few times a week.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Woodside on 3/23/2023 in #fix-my-printer
V3.1 Rear Z Axis -- Sufficient to Just be Parallel?
I got my rear Z axis parallel to the two front ones pretty much dead on. But the entire bar is slightly closer to the left one than the right one. But undoing the screws to scooch it closer to the right one means I have to agonize over getting it parallel again.
As I understand it though, as long as it's parallel, and it's close enough to the middle, it's fine. Because the build plate will just be rotated the faintest amount -- but since it is parallel it'll be consistent and won't matter.
Is this correct?
10 replies