Zig-zag rippling on print
Never seen anything like this before. Weird zig-zag texturing. Causes rippling up vertical edges.
Input shaping is off by the way (tested it with and without).
7 Replies
Kinda hard to see on the hull of the benchy no matter what I do but hopefully it's visible enough
Tightened the screws on the extruder. Seeing if that helps...
Tightening up the extruder did not seem to help at all.
Bump. Saving a similar issue
you use your flow rate is calibrated correctly for that filament?
In the ballpark at least. I've never seen under/over extrusion cause this though.
I'm starting to suspect a bad nozzle, but that'd take buying a new nozzle to test. May just go ahead and order one.
Solution
It appears to have been a bad nozzle
Unfortunate result but yeah, bad nozzle