Voids in layer after detail change
I have some tendrils due to retraction but that's not what I'm worried about.
I don't know what to make of those void layers after the hole starts on the front of the boat. But only at the start, the rest of the hull is fine.
It's not pressure advance, I tested without PA turned on and it was still an issue.
4 Replies
There are similar artifacts on the interior of the boat, always the first couple of layers after a new feature starts.
I think this is because, for some reason, a layer did not star correctly. (if these are starting at seams).
Folks will tell you to tune PA. if you want to just solve the problem and not the underlying issue, try disabling "external perimeters first" if it is enabled. Might work.
(Just saw this reply)
I'll try that. I did tune PA so I knew that wasn't it.
To be fair, it is very closely related to pressure advance.