stylax
RRCRat Rig Community [Unofficial]
•Created by stylax on 7/5/2024 in #fix-my-printer
Deki Goes BRRRRRR at 0% fan speed and full send at boot
Hello all!
I've just installed my new 4028 to my hot end, followed the instructions posted online and the moment I turn the printer on it's goes BRRRRRRRRR and doesn't stop until i put the fan to 100% speed on Mainsail (?!)
Before I route the ground to the hotend as show in this guide, is this the resolution to my problem? My last Deki was fried and it took a while for this one to show up so i don't want to kill another one!!
https://os.ratrig.com/docs/guides/4028/
Info:
RatRig 3.1 300
Octopus 1.1
EBB42 V1.1 toolboard
edit: PWM is connected to the port instructed on the guide.
12 replies
RRCRat Rig Community [Unofficial]
•Created by stylax on 6/1/2024 in #ratos-support
RatOS 2.1 - Change X/Y Stepper Direction
Hello all!
Firstly i'd like that say a huge thank you and congradulations to the devs for the 2.1 update - i can tell a lot of hard work and late nights has gone into this to make Klipper so much easier to work with. GGs!
Now, for my issue, i've just updated from 2.0.2 to 2.1 (new flash) - set up my boards, BTT O v1.1 and EBB42 v1.1 - had a few teething issues at the start, but a few reflashes and things are back to normal (fans just chilling at 100% power when klipper indicated 0 etc)
My problem now is my X and Y go in the wrong direction - before 2.1 i had them set up in reverse with the ! on the direction pin, i had to change the pins around a few months ago as the steppers where stupidly loud, changing the pins on the steppers made them so much quiter and working flawlessly before 2.1. Now we have the new Alias' for board pins, how am i to change the dir pins direction? i've tried adding into the printer.cfg but it doesn't like me changing the direction and spits out errors.
Thank you!
9 replies
RRCRat Rig Community [Unofficial]
•Created by stylax on 4/1/2024 in #fix-my-mesh
Wonky Mesh.. again!
4 replies
RRCRat Rig Community [Unofficial]
•Created by stylax on 3/9/2024 in #fix-my-mesh
Advice on Sqauring Up - Strange mesh
28 replies
RRCRat Rig Community [Unofficial]
•Created by stylax on 3/7/2024 in #fix-my-printer
'Crunchy' Y-Axis Rails - V3.1 300
Hello fellow riggers!
My Y-Axis rails are sounding very crunchy, do you have a recommendation on the best way to clean them and what lubrication/grease should be used?
I've spent a good few hours on reddit posts and YouTube videos about this subject but everyone seems to counter each others points and it's driving me a little crazy so i figured best to ask the guys that know..
I live in the U.K. if you can recommend anything I can grab from a store/amazon!
I live in the U.K. if you can recommend anything I can grab from a store/amazon!
34 replies