RatOS 2.1 - Change X/Y Stepper Direction
Hello all!
Firstly i'd like that say a huge thank you and congradulations to the devs for the 2.1 update - i can tell a lot of hard work and late nights has gone into this to make Klipper so much easier to work with. GGs!
Now, for my issue, i've just updated from 2.0.2 to 2.1 (new flash) - set up my boards, BTT O v1.1 and EBB42 v1.1 - had a few teething issues at the start, but a few reflashes and things are back to normal (fans just chilling at 100% power when klipper indicated 0 etc)
My problem now is my X and Y go in the wrong direction - before 2.1 i had them set up in reverse with the ! on the direction pin, i had to change the pins around a few months ago as the steppers where stupidly loud, changing the pins on the steppers made them so much quiter and working flawlessly before 2.1. Now we have the new Alias' for board pins, how am i to change the dir pins direction? i've tried adding into the printer.cfg but it doesn't like me changing the direction and spits out errors.
Thank you!
7 Replies
I also had to change the direction of X, Y and Extruder. Just add "!" Infront of the pin name
ohhh that might be it! let me check and test. Thank you!
doh! that did it - helps when i look a little closer! 😄 thank you @Yathani
sure .. anytime glad it worked for you
okay, going in the right direction, but now the steppers are quite loud and omtting a high pitched tone....
I did the same mod of changing the pins order to achieve quite stepper buzzing sound but it's only loud during homing with slow speed.
strange that it's almost back to how it was prior to the mod, wonder if putting it back to normal will cure it.
Could be but honestly with how loud the 4028, i didn't bother