RatMonkey Comments - Answer Overflow

RatMonkey

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by ZIMZ on 12/26/2024 in #fix-my-printer

Keenovo Heater pad not heating

If you have a multimeter, disconnect from the SSR and check conductivity/resistance. Could be the thermal fuse.

9 replies

RRCRat Rig Community [Unofficial]

•Created by MFBS on 12/18/2024 in #ratos-support

Just switched my V-Core 3 to hybrid mode.

Check that your electronics enclosure fan is running and unobstructed

8 replies

RRCRat Rig Community [Unofficial]

•Created by reyesv351 on 12/5/2024 in #fix-my-printer

Bed Mesh, Beacon and Bed Issue

0.348 isn't terrible for a 500 and some of it could be caused by the gantry sagging down but that mount doesn't look great. It's a close call and you might be able to straighten up the mounts.

8 replies

RRCRat Rig Community [Unofficial]

•Created by reyesv351 on 12/5/2024 in #fix-my-printer

Bed Mesh, Beacon and Bed Issue

No, worries. the build is stressful, you miss things. Remember, slow is smooth, smooth is fast.

8 replies

RRCRat Rig Community [Unofficial]

•Created by reyesv351 on 12/5/2024 in #fix-my-printer

Bed Mesh, Beacon and Bed Issue

https://docs.ratrig.com/commissioning-guides/v-core-4 The command you need is BEACON_INITITIAL_CALIBRATION

Gaming

Programming