Keenovo Heater pad not heating
Hello all, have any of you had issues with the heater pad not working? I finally got my v-core 4 idex running and had two prints and then the heater pad failed. I checked wiring and the SSR, the heater pad won't heat the bed. Started happening earlier today and not it just won't heat. Any ideas other than warranty?
4 Replies
If you have a multimeter, disconnect from the SSR and check conductivity/resistance. Could be the thermal fuse.
@RatMonkey thank you. Will try.
Was thermal fuse. Replaced and good to go
it was the SSR
It was both the SSR and thermal fuse
Oof, but glad you figured it out
@TheTik thank you. I'm going to put in a ticket to RR about both of them.