DapperDangus
RRCRat Rig Community [Unofficial]
•Created by DapperDangus on 9/21/2024 in #fix-my-resonance
VC4 500mm - Can't figure out toolhead vibrations
20 replies
RRCRat Rig Community [Unofficial]
•Created by DapperDangus on 9/10/2024 in #fix-my-resonance
Could use some guidance on the psd graphs. VC4 500
20 replies
RRCRat Rig Community [Unofficial]
•Created by DapperDangus on 8/29/2024 in #fix-my-printer
Clicking stepper motor.
After doing some calibrations for a bit. Printer has probably only been in motion for less than an hour going through the commissioning guide steps. It started up while I was doing my bed mesh and is very consistent. I’ll post it driving itself as well as me isolating it and driving it manually. Already emailed sales but maybe this can be fixed. Not sure…
139 replies