Tripslip
RRCRat Rig Community [Unofficial]
•Created by Tripslip on 1/1/2025 in #fix-my-printer
skipping A and B's
Im working on getting RatOS running on my 2.4. I am running LDO 42STH48-2804AH's for the A and B. Those steppers are not in the setup wizard so I picked the 2504's. But Im still losing steps in "Performance Mode". Does anyone know if there is a way to fix this without replacing these steppers? I know they are not the "Optimal" steppers but they are very good steppers.
7 replies
RRCRat Rig Community [Unofficial]
•Created by Tripslip on 12/30/2024 in #ratos-support
A/B steppers skipping.
I ran my configurator with LDO-42STH48-2504AC and TMC5160T Pro V1.1.
Im running the...
TMC5160T Pro V1.0
and the LDO 42STH48-2804AH steppers.
Current 1.5
I can home just fine and the first layer seems to be doing ok but as soon as the speed ramps up the steppers skip right off the bat.
Any ideas as to how I can fix this?
21 replies
RRCRat Rig Community [Unofficial]
•Created by Tripslip on 12/29/2024 in #fix-my-printer
! Hotend fan on when should be off !
Im very new to RatOS and Im struggling to get my Voron up and running with RatOS.
My hotend fan funtions are backwards and I know I need to add a " ! " to fix it but I dont know where to add it in the override. Im using an Orbitool O2
10 replies
RRCRat Rig Community [Unofficial]
•Created by Tripslip on 12/27/2024 in #ratos-support
octopus
Can anyone tell me if ratos can run 5160's?
3 replies