! Hotend fan on when should be off !

Im very new to RatOS and Im struggling to get my Voron up and running with RatOS. My hotend fan funtions are backwards and I know I need to add a " ! " to fix it but I dont know where to add it in the override. Im using an Orbitool O2
Solution:
figured it out 🙂
No description
Jump to solution
6 Replies
Solution
Tripslip
Tripslip•3mo ago
figured it out 🙂
No description
blacksmithforlife
blacksmithforlife•3mo ago
Make sure to make that change in your printer.cfg because the ratos.cfg will be overwritten
Tripslip
TripslipOP•3mo ago
I did. thats were I was making my errors. Im setting up RatOS for the first time and learning all od my unknown, unknowns
Théodore
Théodore•5w ago
hey ! i was having the same problem on my v-core 3.1 with ebb42 v1.2 toolboard, here is my solution if anyone needs it : [heater_fan toolhead_cooling_fan] heater: extruder pin: toolboard_t0:PA1 max_power: 0.5 shutdown_speed: 0
blacksmithforlife
blacksmithforlife•5w ago
Please don't hijack someone else's post - also, this is not the solution for the issue OP was having
Théodore
Théodore•5w ago
Oops, sorry i'm new, didn't see the voron part

Did you find this page helpful?