MoyMadrigal
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 12/2/2024 in #fix-my-printer
I can't make the bed mesh
Hi, I had to change a motor because the bearing was damaged but now I can't make the bed mesh. And now it seems as if the motors want to go in opposite directions but only when making the bed mesh.
Plssss helppppp 😭
1 replies
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 9/17/2024 in #ratos-support
RatOS 2.1 vc3.1 and connected to internet
HI all. How to install RatOs 2.1 (I'm in the 2.02-36 ) on a vcore 3.1 to be able to use beacon contact? And do you know if it is possible to connect to the printer with the Internet to access mainsail from anywhere?
10 replies
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 9/12/2024 in #fix-my-print
PETG build-up on my nozzle
2 replies
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 3/19/2024 in #fix-my-resonance
Y is ok but X is not, help please
1 replies
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 3/16/2023 in #fix-my-resonance
strange horizontal Y pattern
7 replies
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 3/16/2023 in #fix-my-print
strange horizontal pattern
11 replies
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 2/1/2023 in #fix-my-print
Very bad surface
hello everyone, I have a v core 500 and it is giving me a very bad surface, with any filament (pla and petg of different brands) I have accelerations of 3000 Max, adjust the PID and everything just in case and the temperature does not fluctuate, the speed is 60 outside and 90 inside
22 replies
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 1/30/2023 in #fix-my-resonance
V core 3.1 500 bad graphics and jerky
5 replies
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 1/24/2023 in #fix-my-printer
Play on X's linear rail
Hello, I have a V core 3 500 with just 400 printing hours, how normal is that the lay? Could it be the cause of these marks on the prints?
12 replies
RRCRat Rig Community [Unofficial]
•Created by MoyMadrigal on 11/30/2022 in #fix-my-printer
Misalignment in the pulleys
16 replies