HA9650- Erased
RRCRat Rig Community [Unofficial]
•Created by HA9650- Erased on 2/1/2025 in #ratos-support
MCU 'mcu' shutdown Timer too close error when running Belt Tension.
VCore 3.1 500 with Manta M8P v.1.0 and CM1 module with RatOS v.2.10 RC3
Toolboard EBB42 v.2.1 attempted both with USB and CANBus with same result
I am able to run the shaper graphs without any issue and get the data transfered with the graphs generated, but the belt tension fails when transferring the data.
10 replies
RRCRat Rig Community [Unofficial]
•Created by HA9650- Erased on 11/4/2023 in #ratos-support
First time starting up a RatRig vcore 3.1 500mm - Controller board fan not running
Hi everyone,
I am trying to figure out wha6t I missed int he configuration of the RatOS for the controller board fan.
I have tried a 4-pin and now just trying to get the 2-pin fan to run.
I am using a Manta M8P with a tool head board which boots up to the RatOS/Klipper screen, but I just do not get the controller fan to work.
Any ideas?
Printer.cfg attached
7 replies