MCU 'mcu' shutdown Timer too close error when running Belt Tension.
VCore 3.1 500 with Manta M8P v.1.0 and CM1 module with RatOS v.2.10 RC3
Toolboard EBB42 v.2.1 attempted both with USB and CANBus with same result
I am able to run the shaper graphs without any issue and get the data transfered with the graphs generated, but the belt tension fails when transferring the data.
Solution:Jump to solution
I swapped out the CB1 for a CM4 and the belt tension and the live view all work well. I never realized how much of a difference there was between the power of the CB1 and CM4.
7 Replies
Timer too close is usualy an error of lack of processing power.
So, the CB1 is not going to support the latest RatOS?
I have only the base configuration without a camera running.
the CB1 was always a experimental option. The official support is for raspberry pi
Ah, this was originally purchased and setup when the raspberry pis were impossible to get.
The CB1 was the only option at that point.
Yeah, now that they are more readily available, better to use an actual pi or compute module
I just got a pi CM4 and working on loading it. Hopefully it will resolve the error. I am just surprised the belt tension is more cpu intensive than the resonance testing.
Solution
I swapped out the CB1 for a CM4 and the belt tension and the live view all work well. I never realized how much of a difference there was between the power of the CB1 and CM4.