HA9650- Erased
RRCRat Rig Community [Unofficial]
•Created by HA9650- Erased on 2/1/2025 in #ratos-support
MCU 'mcu' shutdown Timer too close error when running Belt Tension.
I swapped out the CB1 for a CM4 and the belt tension and the live view all work well. I never realized how much of a difference there was between the power of the CB1 and CM4.
10 replies
RRCRat Rig Community [Unofficial]
•Created by HA9650- Erased on 2/1/2025 in #ratos-support
MCU 'mcu' shutdown Timer too close error when running Belt Tension.
I just got a pi CM4 and working on loading it. Hopefully it will resolve the error. I am just surprised the belt tension is more cpu intensive than the resonance testing.
10 replies
RRCRat Rig Community [Unofficial]
•Created by HA9650- Erased on 2/1/2025 in #ratos-support
MCU 'mcu' shutdown Timer too close error when running Belt Tension.
Ah, this was originally purchased and setup when the raspberry pis were impossible to get.
The CB1 was the only option at that point.
10 replies
RRCRat Rig Community [Unofficial]
•Created by HA9650- Erased on 2/1/2025 in #ratos-support
MCU 'mcu' shutdown Timer too close error when running Belt Tension.
So, the CB1 is not going to support the latest RatOS?
I have only the base configuration without a camera running.
10 replies
RRCRat Rig Community [Unofficial]
•Created by HA9650- Erased on 11/4/2023 in #ratos-support
First time starting up a RatRig vcore 3.1 500mm - Controller board fan not running
Thank you for confirming that one thing is working as intended at least!
7 replies
RRCRat Rig Community [Unofficial]
•Created by HA9650- Erased on 11/4/2023 in #ratos-support
First time starting up a RatRig vcore 3.1 500mm - Controller board fan not running
The Raspberry Pi is running at about 48-50C. I was hoping to cool it a little bit unless not really needed.
7 replies
RRCRat Rig Community [Unofficial]
•Created by HA9650- Erased on 11/4/2023 in #ratos-support
First time starting up a RatRig vcore 3.1 500mm - Controller board fan not running
I just tried homing and found the fan does run when the homing command was issued. I was thinking the fan would be a constant run or based on the temperate of the CPU or board.
7 replies