tillibilli5671 Comments - Answer Overflow

I had the same problem. I think a combination of loosening the screw on the side of the orbiter, and testing a few different retraction speeds fixed it.

8 replies

RRCRat Rig Community [Unofficial]

•Created by tillibilli5671 on 2/25/2025 in #fix-my-resonance

VC4 400 IDEX Resonances on T1

3 replies

RRCRat Rig Community [Unofficial]

•Created by San_Holo on 2/24/2025 in #fix-my-printer

Stepper Driver Overtemp Issue

11 replies

RRCRat Rig Community [Unofficial]

•Created by San_Holo on 2/24/2025 in #fix-my-printer

Stepper Driver Overtemp Issue

I think you have your electronics enclosure backplate reversed, and thus the fan isnt exactly pointing on the drivers

11 replies

RRCRat Rig Community [Unofficial]

•Created by tillibilli5671 on 2/13/2025 in #ratos-support

Realtime Analysis not working

thanks a lot! I've just got it working. I updated some packages and the error didn't come back. But I then realised, that i could't select T0 and T1 as Inputs for the Realtime analysis. I think something with my config was off, as the configurator suddenly showed two copies of T0 instead of T0 and T1. So i reconfigured everything, and manually updated the printer.cfg with my updates. Now everything seems to work the way it should. Thanks for your help!

9 replies

RRCRat Rig Community [Unofficial]

•Created by tillibilli5671 on 2/13/2025 in #ratos-support

Realtime Analysis not working

Hello, I still have this problem unfortunately... In just ran RatOS Doctor which unfortunately didn't help. What would be the next steps here? Backing up my printer.cfg and reinstalling the whole RatOS?

9 replies

RRCRat Rig Community [Unofficial]

•Created by tillibilli5671 on 2/13/2025 in #ratos-support

Realtime Analysis not working

Thanks a lot for checking anyways!:)

9 replies

Gaming

Programming