RgrWilco
RRCRat Rig Community [Unofficial]
•Created by wise-white on 11/15/2023 in #fix-my-print
V-minion carriage type ?
3 replies
RRCRat Rig Community [Unofficial]
•Created by eastern-cyan on 11/15/2023 in #fix-my-print
V-minion carriage type ?
15H
3 replies
RRCRat Rig Community [Unofficial]
•Created by RgrWilco on 3/20/2023 in #ratos-support
Changed shutdown behaviour after upgrading to RatOS 2.0
Sorry for that, I am imagining things or tweaked something I forgot about down the road. Still have sd card with the old image will swap tomorrow. A lot more sober now then Sunday evening.
4 replies
RRCRat Rig Community [Unofficial]
•Created by grumpy-cyan on 3/11/2023 in #fix-my-print
Layer bulging
Always roughtly at the same hight? If so z screw might be binding.
Other idea, look in slicer preview for print speed/features, changes in acceleration/speed does it match the lines?
2 replies
RRCRat Rig Community [Unofficial]
•Created by extended-salmon on 2/27/2023 in #fix-my-print
V-minion improve overhang with stock cooling
What material? Bed temp?
-Slow down on overhangs, allow to cool
-Tune PA, see bulge on corners
-I found once that when there is a brim or mouse-ear underneath it prevents heat from bed, but doubt it'll do anything for this piece
4 replies
RRCRat Rig Community [Unofficial]
•Created by Yathani on 2/24/2023 in #fix-my-printer
Linear rail and Lead Screw lubrication
There is a discussion about it here somewhere.
I use this in the carriage, applied by syringe, it smells but no rust so far.
https://www.amazon.de/dp/B00U1GBQSI/ref=pe_27091401_487024491_TE_item
For the led screw I use some ptfe spray which I also use for my bike, it does not accumalate dust as much. But if it's really required?
20 replies
RRCRat Rig Community [Unofficial]
•Created by like-gold on 2/21/2023 in #fix-my-printer
Help! I am loosing my mind over the ugly layer issue. V-Minion.
Nice setup.
Looks inconsistent extrusion?
Perhaps it's one of these? I'm not an expert by any means, but these have been some of my findings from last years.
-Is the EVA secure to the rail carriage? No loose/partially-tightened screws? Also check the ones underneath the lgx lite, had 2 of those not tightened enough and it gave all kinds of artifacts.
-Screws which secure the x plate to the rail carriage, nice and tight?
-Is the lgx lite having backlash issues? Some reported it.
-Belt tension? Nothing rubbing?
-Pulleys nice and tight?
-No squeaking noices from the idlers?
-The hotened is nice and tight, no wobbling at the heatbreak?
-Other sources of vibrations/resonances?
- I tried one of these wasmachine dampener mats before it did not do much good, switched it to a concrete slab, which was better suited
-What material is this in? If cooling fan is enabled, try putting it low.
29 replies