V-minion improve overhang with stock cooling
I’m struggling to print this x_gantry_end_cap part with overhang.
I’m already on the lowest nozzle temp recommended for the filament 230 deg C. Max fan speed on bridging/overhang but I still get this curling.
Any tips will be much appreciated! Thanks!
3 Replies
What is "stock cooling", is it a single 5015?
curious-teal•2y ago
What material? Bed temp?
-Slow down on overhangs, allow to cool
-Tune PA, see bulge on corners
-I found once that when there is a brim or mouse-ear underneath it prevents heat from bed, but doubt it'll do anything for this piece
stormy-goldOP•2y ago
I found the issue. My extrusion multiplier is wrong, I based it on the calibration result from SuperSlicer. Apparently it’s to big ~1.0 something, I backed it down to ~.95