mystefix.
mystefix.
RRCRat Rig Community [Unofficial]
Created by MACBEAN on 11/5/2024 in #fix-my-print
Layers not sticking past layer 3
Hi @MACBEAN do you have the correct nozzle diameter configured in your slicer ? I had similar problems until i found out that i had a 0.6 instead of a 0.4 nozzle in the hot end installed.
3 replies
RRCRat Rig Community [Unofficial]
Created by Kälte Kiste on 10/16/2024 in #german-support
Temperatur Problem nach Update 2.1 an Z2 Motor / Treiber
Hast du mal geschaut, ob die aktive Lüftung der Treiber komplett läuft? Hatte so ein Phänomen auch beim Umstieg auf 2.1 Am Ende hatte sich nur einer von 2 Lüftern gedreht und somit wurden 2 Treiber zu heiß. Hab dann auf einen großen Lüfter umgebaut und seitdem ist alles wieder kühl 😊
6 replies
RRCRat Rig Community [Unofficial]
Created by millenford - VC4 300h on 9/5/2024 in #ratos-support
Would an SSD (vs the SD card) speed up full updates on RPi 4B?
I'm using since quite a while a usb stick ( usb 3.x) with the pi (3B) and it is working quite well and also faster than a SD card.
44 replies
RRCRat Rig Community [Unofficial]
Created by mystefix. on 7/14/2024 in #fix-my-resonance
are the shaper graphs fine ? V-Core 3.1 300m with RR Toolhead Beta 2
alright, thanks @Ross13 for the quick answer 🙂 Will have another look at the toolhead related to the cable management and use MZV for both axies. Will update the thread once i had a look at the cable management on the toolhead.
4 replies