K2Van CR-6 & Vcore 3.1 500 IDEX
RRCRat Rig Community [Unofficial]
•Created by K2Van CR-6 & Vcore 3.1 500 IDEX on 10/28/2024 in #ratos-support
Homing and "move exceeds maximum extrusion" errors after a canceled print.
I am getting errors when restarting a print after a canceled print. When starting a new print without a firmware restart I get "Must home axis first: -72.166 250.501 15.000 [25.400]" It tries to home Y before X. If I home X manually it will happily home and start the print.
When laying down the prime blob I then get "Move exceeds maximum extrusion (2.792mm^2 vs 0.640mm^2)"
This happens consistently after canceling a print. doing a firmware reset is enough to fix it.
5 replies
RRCRat Rig Community [Unofficial]
•Created by K2Van CR-6 & Vcore 3.1 500 IDEX on 10/6/2024 in #ratos-support
1 cm shift after pause
When I print an object I get repeatable an exactly 1cm shift to the right when resuming the print. I first suspected a loose belt of similar, chencked the mechanics but can't find anything. Then as I was testing the new Orcaslicer I reverted back to Prusaslicer with the exact same result. Also checking the gcode in gcodeanalyzer.com seems to be as expected.
Weird is that printing a primitive with a pause does go allright.
In Prusa slicer I had to insert "PAUSE" to trigger the amcro, Prusa inserts M601 which is not picked up by RatOS (Orca inserts PAUSE by default).
Attached are the RatOS console output, actual gcode and model.
15 replies
RRCRat Rig Community [Unofficial]
•Created by K2Van CR-6 & Vcore 3.1 500 IDEX on 2/11/2024 in #fix-my-resonance
V-core 500 IDEX terrible Y axis while X axis is quite OK
6 replies
RRCRat Rig Community [Unofficial]
•Created by K2Van CR-6 & Vcore 3.1 500 IDEX on 1/27/2024 in #fix-my-mesh
Vcore 3.1 500 IDEX
2 replies