Homing and "move exceeds maximum extrusion" errors after a canceled print.
I am getting errors when restarting a print after a canceled print. When starting a new print without a firmware restart I get "Must home axis first: -72.166 250.501 15.000 [25.400]" It tries to home Y before X. If I home X manually it will happily home and start the print.
When laying down the prime blob I then get "Move exceeds maximum extrusion (2.792mm^2 vs 0.640mm^2)"
This happens consistently after canceling a print. doing a firmware reset is enough to fix it.
3 Replies
please clean your console output, run
ENABLE_DEBUG , reproduce the error and then share the console outputSorry for the delay but this is the output of the test print untill it was canceled and the output of a follow-up print.
I will probably not be able to follow up for next week as I travel to China, upon return I will check.