jolton49
RRCRat Rig Community [Unofficial]
•Created by jolton49 on 10/14/2024 in #fix-my-print
Color change Layer Adhesion
Same petg 1.75mm
3 replies
RRCRat Rig Community [Unofficial]
•Created by Steppe_Warrior on 8/20/2024 in #fix-my-print
And here we go again... first layer problem even with beacon3D
I think someone else mentioned the ptfe tube being an issue because it's such a long run and if you clamp everything right with zip ties it causes binding issues.... This may not be your solution but if you are desperate enough it might be worth looking into
80 replies
RRCRat Rig Community [Unofficial]
•Created by jolton49 on 8/20/2024 in #fix-my-print
Ratcube Ringing on Vcore4 hybrid
12 replies
RRCRat Rig Community [Unofficial]
•Created by jolton49 on 8/20/2024 in #fix-my-print
Ratcube Ringing on Vcore4 hybrid
Oh man thanks chicken, good catch! The belt tension graph is with hybrid belts installed. I am using the latest version of prusaslicer
12 replies
RRCRat Rig Community [Unofficial]
•Created by jolton49 on 8/20/2024 in #fix-my-print
Ratcube Ringing on Vcore4 hybrid
For my slicer I set petg speeds to 40mm/S and acceleration max were all capped at 5700 or slower
12 replies
RRCRat Rig Community [Unofficial]
•Created by jolton49 on 8/20/2024 in #fix-my-print
Ratcube Ringing on Vcore4 hybrid
12 replies
RRCRat Rig Community [Unofficial]
•Created by jolton49 on 8/3/2024 in #fix-my-resonance
vcore 4 500 belt issues....at a loss
Sorry I was playing with belt tension as well as removing the top....I need to make 1 change at a time
9 replies
RRCRat Rig Community [Unofficial]
•Created by ptegler on 8/4/2024 in #fix-my-resonance
Kinda' stunned... do these still look good to you?
How do you set a constant hz in rates?
12 replies
RRCRat Rig Community [Unofficial]
•Created by jolton49 on 8/3/2024 in #fix-my-resonance
vcore 4 500 belt issues....at a loss
9 replies