Color change Layer Adhesion

I have a V-core 4 500 and it works fine on single color prints. I just started to play with the Color Change feature in Prusaslicer and it seems everything I change out the filament (single extruder) and resume the print, the printer is extruding at a higher level than before the pause and I'm not getting good layer Adhesion. Any tips on how to fix this?
No description
No description
2 Replies
TheTik
TheTik5mo ago
stuipid question, but those are all the same kind of filament right?
jolton49
jolton49OP5mo ago
Same petg 1.75mm

Did you find this page helpful?