drops
RRCRat Rig Community [Unofficial]
•Created by drops on 9/14/2024 in #fix-my-print
prime line keeps digging
4 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 6/3/2024 in #fix-my-print
Primeline RatOS 2.1
Primeline not working in new ratos 2.1 , primeblob working , changed to 'primeline' and when the print starts , it just skips it. No error, no output in terminal.
12 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 5/31/2024 in #ratos-support
RAT OS 2.1 RC1 Homing Issue
37 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 10/28/2023 in #fix-my-resonance
Y always low
10 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 10/22/2023 in #ratos-support
Change move position after homing axis
After homing X axis, I want the toolhead to move elsewhere besides 'middle', before homing Y. Just change toolhead and Y axis hits the Z screw. So I want to change to something like 150/350, then do the normal center before starting printing or after the home macros
18 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 10/4/2023 in #fix-my-print
circle not round
17 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 7/24/2023 in #fix-my-print
Single wall issue
3 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 2/8/2023 in #ratos-support
How do I get the klipper log?
I tried ssh into pi but didnt find it.
2 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 2/8/2023 in #ratos-support
Extruder reset Temp after starting print
Usually I turn my printer on, then depending the filament heat up my bed,and nozzle. While im doing that I go ahead and slice my file, and upload. Lately tho right after starting the print, mesh and primeblob it stops because extruder temp too low. For some reason right before the primeblop it will forget to keep my temp.
3 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 2/6/2023 in #ratos-support
When does RatOs load 24v-0.8a-e.cfg vs instead of 24v-0.7a-e.cfg
For Orbiter Extruder
7 replies
RRCRat Rig Community [Unofficial]
•Created by drops on 1/18/2023 in #fix-my-resonance
What to do with acceleration?
After getting my graphs, what do I do with the acceleration suggestions? In klipper you usually choose acceleration, and you dont have x and y , just MAX, so do I put the lowest of the two? Also in superslicer, you do get acceleration for x or y, can you put those in their? What happens when its moves if acceleration is different for x and y?
3 replies