Matthias
RRCRat Rig Community [Unofficial]
•Created by Matthias on 1/10/2025 in #fix-my-printer
Clicking noise when moving gantry
I also narrowed it down to the teethed pulley or the motor. Loosening the two worm screws on the pulley makes the clicking noise disappear. Tightening them so the motor turns leads to the clicking sound.
Really frustrated...I don't want to remove the hybrid system, change pulleys and/ or motors and redo the whole calibration 😦
Seems like there is no way around it.
Guess I will be writing to ratrig support as this is definitely a hardware issue.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Matthias on 9/11/2024 in #fix-my-mesh
VC4 500 bed replaced -> mesh now ok?
thank you. I will probably try to raise the front slightly. The new bed is way better than the previous one (0.147 vs 0.98 range)
10 replies
RRCRat Rig Community [Unofficial]
•Created by Matthias on 9/11/2024 in #fix-my-mesh
VC4 500 bed replaced -> mesh now ok?
Printer is a vc4 500....for some reason my topic got messed up...sorry about that
10 replies
RRCRat Rig Community [Unofficial]
•Created by Matthias on 8/23/2024 in #fix-my-mesh
Wave on vcore 4 500 mesh
Will try with a 20cm GG00 one tomorrow. Thank you for your help so far 🙂
18 replies
RRCRat Rig Community [Unofficial]
•Created by Matthias on 8/23/2024 in #fix-my-mesh
Wave on vcore 4 500 mesh
I will try to get my hands on a larger straight-edge. But according to my 10cm tool there is actually a "wave" in the bed.
18 replies
RRCRat Rig Community [Unofficial]
•Created by Matthias on 8/23/2024 in #fix-my-mesh
Wave on vcore 4 500 mesh
If it were just the corners I would try further adjustmens, But I don't know how to counter those waves towards the middle of the bed
18 replies
RRCRat Rig Community [Unofficial]
•Created by Matthias on 8/23/2024 in #fix-my-mesh
Wave on vcore 4 500 mesh
that is what worries me ^^
18 replies
RRCRat Rig Community [Unofficial]
•Created by Matthias on 8/23/2024 in #fix-my-mesh
Wave on vcore 4 500 mesh
Only got a short 10cm one. I can actually "tilt" the tool a bit on the left front (where the top of the wave is according to the mesh) and I see a small "dent" under it in the right front
18 replies