VC4 500 bed replaced -> mesh now ok?

Got my replacement bed today and ran a new mesh.
Range is 0.147, dipping slightly on the front right corner. I will try to raise that corner slightly. Is the rest fine so I can proceed?

MatthiasOP•9/11/24, 8:19 AM

Printer is a vc4 500....for some reason my topic got messed up...sorry about that

Jamorro•9/11/24, 8:38 AM

rest is fine yes

Jamorro•9/11/24, 8:39 AM

0.1 is a very minor adjustment as well. If you wanna hunt for perfection you can go for it but i would just have continued

MatthiasOP•9/11/24, 8:44 AM

thank you. I will probably try to raise the front slightly. The new bed is way better than the previous one (0.147 vs 0.98 range)

Jamorro•9/11/24, 8:45 AM

helge or some other knowledgeable people here have commented that everything under 0.1% of the bedsize should be considered normal which means under 0.5 is acceptable

Jamorro•9/11/24, 8:46 AM

think i have like 0.15 on my 300

MMatthias thank you. I will probably try to raise the front slightly. The new bed is way b...

VisualTech48•9/11/24, 9:46 AM

You can't raise the front your X gantry or the bed is at fault. If you lifted your X gantry in the middle slightly the bed would just correct itself by that tiny ammount but as soon as you heat it up it will go down again.

VisualTech48•9/11/24, 9:46 AM

If you are on the normal 2020 extrusion.