Tetradecar

PostsComments

RRCRat Rig Community [Unofficial]

•Created by Tetradecar on 1/20/2025 in #fix-my-printer

Hotend change, what I need to change in klipper and slicer?

14 replies

RRCRat Rig Community [Unofficial]

•Created by Tetradecar on 12/27/2024 in #fix-my-printer

New Hotend for v-minion v1.0 and eva 2.4.2

Hey guys, My dragonfly bmo on my v-minion v1.0 is broken. Now I want to replace it with a new hotend. I have read some recommendations but I am not shure what to buy. The Dragon hotend was recommended because it is maintenance free, no clogging. The Rapdio is also a good hotend. But it looks like the fan needs to be more powerful. And as I don't print that fast, I don't need a UHF version. I would go for the Dragon HF version, but I am not sure if the printed part of the eva 2 is compatible with the Dragon HF version. https://2.eva-3d.page/hotends/dragon/ And do I need to print other parts? The problem is that I don't have a second printer and a friend of mine is printing the ABS parts for me. I am open for recommendation. Thanks and greetings!

2 replies

RRCRat Rig Community [Unofficial]

•Created by Tetradecar on 12/6/2023 in #fix-my-print

Print bed adhesion because of worn print bed?

Hey, For a few days now, I can't print on my V-Minion because the print bed adheres poorly or not at all when I print a simple square without a brim. I cleaned the bed with dish soap and isopropanol. Calibrated the Z-offset and did a PID tune. And this happened with several different PLAs that worked fine before. I don't know what to check next. Is it possible that the print bed is worn out?

21 replies

RRCRat Rig Community [Unofficial]

•Created by Tetradecar on 11/29/2023 in #ratos-support

Manually install RatOS-configuration on Mainsail for V-Minion

Hey, Today I installed MainsailOS on my OrangePi Zero2. Cloned RatOS-configuration.git to ~/printer_data/config/RatOS/. Tried to install it with ./scripts/ratos-install.sh, but got an error about the beacon service that I can't reproduce at the moment. I then used the v-minion install script and rebooted. It seems to work. So I updated the moonraker.conf with the [update_manger client RatOS] from my original RatOS. But I got an error from klipper Section 'ratos_homing' is not a valid config section, I dont know how to fix this. And I dont know if this is the right way to install the configurations. Greeting

20 replies

RRCRat Rig Community [Unofficial]

•Created by Tetradecar on 11/28/2023 in #ratos-support

RatOS on Orange Pi Zero 2 or other non RPis?

Hey, I got an Orange Pi Zero 2 here and want to replace the RPi3A+ because it got no LAN-Port and only one USB-Port. It is possible to get RatOS running on it? I know that, I can install armbian, Klipper over KIAUH and add the Repo for the Printer Configs and Theme manually.
How is that without RatOS to compile Klipper Firmware for the controller boards? Thanks!

3 replies

RRCRat Rig Community [Unofficial]

•Created by Tetradecar on 11/2/2023 in #ratos-support

legacy csi webcam not connecting

5 replies