MRNicegamer
RRCRat Rig Community [Unofficial]
•Created by MRNicegamer on 1/5/2025 in #fix-my-print
It looks like overextrusion but only on certain prints
The fan turns on to 40% when its doing the overhangs.
6 replies
RRCRat Rig Community [Unofficial]
•Created by MRNicegamer on 1/5/2025 in #fix-my-print
It looks like overextrusion but only on certain prints
Im printing with ABS so the cooling Fans are always off
6 replies
RRCRat Rig Community [Unofficial]
•Created by MRNicegamer on 1/1/2025 in #fix-my-printer
metal "klunking" noise and seemingly loosing steps
well it somehow fixed itself when I enabled Performance mode.
8 replies
RRCRat Rig Community [Unofficial]
•Created by MRNicegamer on 1/1/2025 in #fix-my-printer
metal "klunking" noise and seemingly loosing steps
I think its coming from the linear rails from the Y axis. The sound also alternates between the rails.
8 replies
RRCRat Rig Community [Unofficial]
•Created by MRNicegamer on 1/1/2025 in #fix-my-printer
metal "klunking" noise and seemingly loosing steps
8 replies
RRCRat Rig Community [Unofficial]
•Created by MRNicegamer on 1/1/2025 in #fix-my-printer
metal "klunking" noise and seemingly loosing steps
well I did but I couldn´t find anything that was loose.
8 replies
RRCRat Rig Community [Unofficial]
•Created by Yeugen on 12/22/2024 in #fix-my-mesh
Bed Mesh on V-Core 4 500mm IDEX
7 replies
RRCRat Rig Community [Unofficial]
•Created by MRNicegamer on 12/29/2024 in #fix-my-printer
X cariage moves slightly along the Y axis while homing X axis
that was the Problem thanks for the help. I was just a bit confused by the manual because it never specified that you have to have the hybrid belts when you built the IDEX variant.
7 replies
RRCRat Rig Community [Unofficial]
•Created by MRNicegamer on 12/29/2024 in #fix-my-printer
X cariage moves slightly along the Y axis while homing X axis
alright Im going to attach the hybrid belts.
7 replies
RRCRat Rig Community [Unofficial]
•Created by MRNicegamer on 12/29/2024 in #fix-my-printer
X cariage moves slightly along the Y axis while homing X axis
I know but in the instructions it says that you should do the initial calibration first before you attach the hybrid belts. Should I just instal the hybrid belts and see if that helps?
7 replies