X cariage moves slightly along the Y axis while homing X axis
Whenever I home the X axis the whole X cariage moves a little bit along the Y axis. I tried to loosen the belts because I thought they were too tight but it didn´t change anything. I don´t really have any experience with this sort of stuff and when I tried to look on Google for the answer I couldn´t find anything so this is sort of my last resort. I have a VCore 4 500 IDEX but since the manual said so I didn´t put the Hybrid belts on yet.
4 Replies
If you're doing IDEX, you have to attach the hybrid belts.
I know but in the instructions it says that you should do the initial calibration first before you attach the hybrid belts. Should I just instal the hybrid belts and see if that helps?
From what I've read in here, those "initial calibration first" only applies to hybrid. If you're doing IDEX you have to have the additional set of belts attached otherwise the motion system isn't fully constrained. Hence the extra movement
alright Im going to attach the hybrid belts.
that was the Problem thanks for the help. I was just a bit confused by the manual because it never specified that you have to have the hybrid belts when you built the IDEX variant.