Martijn Janssen
Explore posts from serversRRCRat Rig Community [Unofficial]
•Created by Martijn Janssen on 11/10/2024 in #fix-my-printer
Cutting into belt
1 replies
RRCRat Rig Community [Unofficial]
•Created by Martijn Janssen on 7/24/2023 in #ratos-support
Repo has untracked source files
Hi,
Returned from holiday and updated my RatOS system with the latest updates from RatOS v2, Klipper, Moonraker and MainSail.
Updates finished succesfully, but my Host shows v0.11.0-248-gd725dfd3-dirty as version and in the Update Manager it shows with Klipper:
Repo has untracked source files: ['klippy/extras/gcode_shell_command.py', 'klippy/extras/linear_movement_vibrations.py', 'klippy/extras/pam.py', 'klippy/extras/ratos_homing.py']
and with Moonraker:
Repo has untracked source files: ['moonraker/components/timelapse.py']
Everything seems to work fine though. Nothing shows as dirty in Update Manager
Found that this is basically output from GIT.
Is this just cosmetic, or do I need to do/change/add anything?24 replies
RRCRat Rig Community [Unofficial]
•Created by Martijn Janssen on 5/19/2023 in #fix-my-printer
Too slow?
Not sure where to look next. My V-Core-3 300 can't print faster than 150mm/s at about 20 mm³/sec without serious underextrusion. From what read, this should be faster. At 150mm/s the prints look great.
I run an Orbiter 2.0 with a Rapido UHF with the 0.6 Volcano nozzle.
When pushing the speed/flow, the Orbiter doesn't skip any steps and the nozzle isn't jammed.
Filament path is uncontrained, with only the Orbiter Filament Sensor, but also tried it without.
Using Capricorn tubes for the places that require PTFE tubing.
What can cause this?
20 replies
RRCRat Rig Community [Unofficial]
•Created by Martijn Janssen on 5/14/2023 in #ratos-support
RatOS on a Prusa MK3S+
Is there a guide available for using RatOS on a Prusa MK3S+? Or is it as simple to install as it is on a RatRig?
3 replies
RRCRat Rig Community [Unofficial]
•Created by Martijn Janssen on 4/15/2023 in #fix-my-print
Non consistent infill
14 replies