kyle
RRCRat Rig Community [Unofficial]
•Created by kyle on 6/9/2024 in #ratos-support
RatOS and PT1000 B Thermistor
Thank you! I am using an EBB36 right now with it, and am using the TH0 pins. Is this okay?
6 replies
RRCRat Rig Community [Unofficial]
•Created by kyle on 1/5/2024 in #fix-my-print
Lines Across Prints
14 replies
RRCRat Rig Community [Unofficial]
•Created by kyle on 1/5/2024 in #fix-my-print
Lines Across Prints
I’ve done some flow tests and stuff. Let me give a temp tower a try this evening and I will post results.
14 replies
RRCRat Rig Community [Unofficial]
•Created by kyle on 1/5/2024 in #fix-my-print
Lines Across Prints
Layer height is 0.3mm with a 0.6mm nozzle. Speed is 100mm/s. Fan speed is 100%
14 replies
RRCRat Rig Community [Unofficial]
•Created by NewCalJs on 12/13/2023 in #fix-my-print
VCORE 500 - Is the mesh taken in account ?
@Moderator Been almost a month since this was posted, how can we help this guy?
8 replies
RRCRat Rig Community [Unofficial]
•Created by kyle on 12/22/2023 in #fix-my-resonance
Input Shaper is on, but still getting ghosting
Wondering if I should just have the default acceleration in the slicer at Zero, then just control it through Klipper/RatOS?
7 replies
RRCRat Rig Community [Unofficial]
•Created by kyle on 12/22/2023 in #fix-my-resonance
Input Shaper is on, but still getting ghosting
7 replies
RRCRat Rig Community [Unofficial]
•Created by kyle on 12/22/2023 in #fix-my-resonance
Input Shaper is on, but still getting ghosting
I should probably lower the acceleration to under the limit for the shaper, right? Any advice on a good place to start with these numbers?
7 replies
RRCRat Rig Community [Unofficial]
•Created by kyle on 12/22/2023 in #fix-my-resonance
Input Shaper is on, but still getting ghosting
7 replies
RRCRat Rig Community [Unofficial]
•Created by kyle on 12/22/2023 in #fix-my-resonance
Input Shaper is on, but still getting ghosting
Any able to help me troubleshoot this?
7 replies