Lines Across Prints
RatRig V-Core 23.1 500. LGX Lite Extruder, Rapido 2.0 hotend, 0.6mm UHF diamond back nozzle. Printing with Overture PETG at 230C and bed temp of 80C.
7 Replies
what is the fan speed, layer hight, speed?
Layer height is 0.3mm with a 0.6mm nozzle. Speed is 100mm/s. Fan speed is 100%
is this the first print with the filliment
if so try a temp tower as i think you are running hot
most of my petg i run at 220 or 225 at most
I’ve done some flow tests and stuff. Let me give a temp tower a try this evening and I will post results.
cool will wait to see
Looks awful. Going to dry the filament again and also try rotation distance tuning again. Seems like it is over extruding, right?
After you test that try a layer height of .3 but 50mm/s on the benchy
What might be the case is that you are outputting to much thermal mass for your cooler
50mm/s is prob way slower then you can get away with but it's a good start for testing
What is your cooling setup