Input Shaper is on, but still getting ghosting
V-core 3.1 500. I have done SHAPER_CALIBRATE and input shaper is in the printer cfg, but still getting ghosting. I thought my graphs were looking good, but I guess not.
What can I do to prevent ghosting and ringing like I am getting on this temp tower?
What can I do to prevent ghosting and ringing like I am getting on this temp tower?
6 Replies
Any able to help me troubleshoot this?
Change X shaper config from ZV to MZV. ZV works only for very narrow band of frequency MZV will cancel out bigger range of resonances. What speed / acceleration settings are you printing at?
The default profile for Vcore 3.1 500 in Orcaslicer. I have not gotten to tune speeds yet but figured if this was the default it should work.
I should probably lower the acceleration to under the limit for the shaper, right? Any advice on a good place to start with these numbers?
Here is what superslicer uses as a default. Maybe I should switch to these?
Wondering if I should just have the default acceleration in the slicer at Zero, then just control it through Klipper/RatOS?